No Products in the Cart
Equilibrium moisture content is ideally measured in a bore hole in the material. The thin humidity probe with a probe shaft diameter of 4 mm (connected to an appropriate measuring instrument) is good to use here, so as to keep the bore hole as small as possible. It should be protected against contamination by a PTFE cap during measurement. The bore hole can easily be sealed with adhesive modelling clay.
The material moisture can also be determined directly in the instrument in combination with the testo 635 temperature and humidity measuring instrument. The attached measuring instrument (testo 635) automatically calculates the material moisture based on the measured equilibrium moisture content and shows this in the display. The material moisture calculation is available for the following materials: concrete, high-insulation brick, solid brick, hard wood, soft wood, aerated concrete, particle board, calcium sulphate flowing screed, cement flowing screed and lime sand brick.
| Sensor | ||
| Temperature - NTC | Humidity - Capacitive | |
| Measuring range | 0 to +40 °C | 0 to +100 %RH |
| Accuracy | ±0.2 °C *Please also take into account the device uncertainty. |
±2 %RH at +25 °C (+2 to +98 %RH) ±0.15 %RH/K (k=1) long-term stability: ±1 %RH / year *The sensor accuracy corresponds to the system accuracy. |
Buy with 100% confidence knowing your purchase is backed by the full Manufacturer's Warranty.
Australia-wide Flat Rate shipping of $15.00 per order.
This includes multiple products up to 5kg only.
Additional cost applies for orders over 5kg. Contact us for quotation.
